To
program the temperature sensor module, set the
network number and device number in the same way
you set the garage door sensor. Following this,
set the upper and lower temperature limits. LED1
and LED2 flash to prompt you to program of the
upper temperature limit tens digit. Press S101
to cycle the value and S102 to enter.
LED3
and LED4 blink to indicate that the upper limit
ones digit should be entered in the same manner.
The two inner LEDs prompt the entry of the lower
limit tens digit. The outer two LEDs are for the
entry of the lower limit ones digit.
That’s
it. When you’re done programming, you can place
the temperature sensor in the area that you want
to monitor.
